How to Assemble the Adrian Toddler Table & Chair Set

By Avenlur: Swedish Ladders, Jungle Gyms & Outdoor Playsets | Published: 2026-10-27

Category: How-to Guides

Follow these step-by-step instructions to assemble the Avenlur Adrian Adjustable Toddler Table & Chair Set. Avoid common mistakes and get the height right for your child.

Quick Answer

Assembling the Avenlur Adrian Toddler Table & Chair Set takes about 30 minutes with a Phillips screwdriver. The key is to set the table height before tightening all bolts and to avoid overtightening the chair legs.

Before You Start: What You Need

The Adrian set arrives in two boxes — one for the table and one for the two chairs. Unpack everything on a soft surface to avoid scratching the wood. You will need a Phillips screwdriver (not included) and a clean, flat workspace. The included Allen key works for most bolts, but a screwdriver helps with the chair seat screws.

Choosing the Right Height

The table adjusts from 14.76 inches to 20.9 inches. Measure your child's seated elbow height: the tabletop should sit about 2 inches below their bent elbow. For a toddler (age 18 months to 3 years), start at the lowest setting. For a preschooler (age 3 to 5), try the middle or higher setting. You can change the height later, but it is easier to set it correctly during assembly.

Assembly Steps

Step 1: Attach the Table Legs: Insert the four table legs into the pre-drilled holes on the underside of the tabletop. Use the Allen key to loosely tighten the bolts. Do not fully tighten yet — you need some play to align the height adjustment mechanism. Common mistake: tightening bolts fully now makes it hard to adjust the height later. Leave them finger-tight.
Step 2: Set the Table Height: Locate the height adjustment brackets on each leg. Slide the bracket to your desired height (14.76 inches for toddlers, higher for older kids). Ensure all four brackets are at the same height by measuring from the tabletop to the bracket top on each leg. Checkpoint: use a ruler or tape measure — eyeballing leads to a wobbly table.
Step 3: Tighten All Table Bolts: Once the height is set, tighten all bolts firmly with the Allen key. Work in a crisscross pattern (tighten one, then the opposite leg) to keep the tabletop level. Give each bolt a final quarter turn to ensure it is snug, but do not strip the wood. Common mistake: overtightening can crack the wood or strip the bolt head. Stop when you feel resistance.
Step 4: Assemble the Chairs: For each chair, attach the two side pieces to the seat using the provided screws and a Phillips screwdriver. Then attach the backrest. Finally, screw the four legs into the pre-threaded inserts on the underside of the seat. Tighten all screws by hand until snug. Checkpoint: ensure the chair legs are fully seated — a partially screwed leg can wobble and tip.
Step 5: Final Check and Placement: Place the table on a flat surface and check for wobble by gently pressing each corner. If it rocks, loosen the bolts on the wobbly leg slightly, adjust the bracket, and retighten. Place the chairs next to the table and test that they sit level. Wipe the set with a dry cloth to remove any dust from assembly. Common mistake: placing the set on an uneven floor. Use a rug or felt pads under the legs if your floor is not perfectly level.

Product Used in This Guide

Adrian | Adjustable Toddler Table & Chair Set: The Adrian Multi-Height Adjustable Table and Chairs Set is crafted from wood and inspired by Montessori principles, with a height range from 14.76 inches up to 20.9 inches. This wide adjustment range lets the set grow with your child from toddler to preschool years, so you only need to buy one table and chair set.
Adrian | Adjustable Toddler Table & Chair Set